![]() ![]() The product should be connected to a power supply only of the type described in the operating instructions or as marked on the product.Ĩ. The product should be located away from heat sources such as radiators, heat registers, or other products that produce heat.ħ. The product should be located so that its location or position does not interfere with its proper ventilation.Ħ. If you experience any hearing loss or ringing in the ears, you should consult an audiologist.ĥ. Do not operate for a long period of time at a high volume level or at a level that is uncomfortable. This product, either alone or in combination with an amplifier and speakers or headphones, may be capable of producing sound levels that could cause permanent hearing loss. This product should be used only with a stand or cart that is recommended by the manufacturer.Ĥ. Do not use this product near water - for example, near a bathtub, washbowl, kitchen sink, in a wet basement, or near a swimming pool, or the like.ģ. Read all of the Safety and Installation Instructions and Explanation of Graphic Symbols before using the product.Ģ. WARNING: When using electric products, basic precautions should always be followed, including the following:ġ. PC2 Programs and Controller Assignments.Line-Level Left and Right Analog Audio Outputs.Installing an Operating System or Setups.Envelope Menu: Percussion Pitch Parameters.The Envelope Menu: Percussion Parameters.The Controllers Menu: Switch Controller Parameters.The Controllers Menu: Ribbon Controller Parameters. ![]() The Controllers Menu: Continuous Controller Parameters.Recording to a Sequencer While in MIDI Setups Mode.Sending Bank-Select and Program-Change Messages.Using the PC2 to Control External Slaves.Using the Arpeggiator with a Sequencer or External Controller.Using Pressure (Aftertouch) as an Arpeggiator Controller.Controlling Vibrato and Tremolo with LFOs.Making Effects Active at Program or Setup Selection.A Few Important Points About Entry Values.Assigning Sliders to Control Wet/Dry Mix in Different Zones.Setting Initial Volume Levels for Different Zones.Changing the AutoSplit Key Without Editing.Using AutoSplit for Quick Layers and Splits. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |